Description: The belt counter has reached the life value.
Remedy: 1) Is the error message displayed? 2) Does the error occur soon after Belt unit replacement? Check the belt life. Replace the Belt unit immediately or at the next maintenance.
Code: -
Display: Replace Fuser
Description: The fuser counter has reached the lifevalue
Remedy: 1) Is the error message displayed? 2) Does the error occur soon after Fuser unit replacement? Check the fuser life. Replace the Fuser unit immediately or at the next maintenance.
Code: -
Display: Job Offset Home Error
Description: The Job offset assy does not operate or cannot detect the home position.
Remedy: Does the Job offset assy operate normally? Replace the Job offset sensor. Replace the Job offset motor or Engine board.
Code: -
Display: Running Short of Paper in Tray
Description: Running short of paper detected
Remedy: Does only small mount of papers (approx. 30 sheets or less) remain? Load papers. Check the Paper near end sensor.
Code: -
Display: Disc Operation Error
Description: HDD cannot be written.
Remedy: Is the operating procedure correct? Confirm the procedure in the manual. Replace the HDD as it is broken.
Code: 001 ... 011
Display: Service Call 001: Error ~ 011: Error
Description: CPU Exception
Remedy: Is the error message displayed again? Turn the printer off/on. Replace the SWA board. (The EEPROM needs replacement.)
Code: 020
Display: Service Call 020: Error
Description: CU ROM Hash Check Error 1
Remedy: Is the program ROM DIMM installed properly? Can the printer recover from the error by replacing the program ROM DIMM? Re-install the program ROM DIMM. Replace the program ROM DIMM. Replace the SWA board. (The EEPROM needs replacement.)
Code: 030
Display: Service Call 030: Error
Description: CU Slot1 DIMM RAM Check Error
Remedy: Is the concerned RAM DIMM installed properly? Can the printer recover from the error by replacing the RAM DIMM? Re-install the concerned RAM DIMM. Replace the RAM DIMM. Replace the SWA board. (The EEPROM needs replacement.)