• Code: 181, 182
• Display: Service call 181:Error 182:Error
• Description: Option unit I/F error. 181 = Duplex Unit 182 = Option Tray)
• Remedy: Does error reoccur? Yes Turn power ON again. After checking connection parts of connector, replace option unit.

• Code: 190
• Display: Power off/on 190:Error
• Description: System Memory Overflow.
• Remedy: Does error reoccur? Yes Turn power ON again. Add option RAM DIMM.

• Code: 200 ... 202
• Display: Service call 200 ~ 202 Error
• Description: PU Firmware download Error.
  Error occurred while writing over the PU firmware.
• Remedy: Error occurered while writing over the PU firmware. Turn the printer OFF/ON, and retry to download the PU firmware again. (Usually, the procedure (PU firmware download) which isn’t done, so this is not occur.)

• Code: 203 ... 214
• Display: Power off/on Error codes 203,204, 207, 208, 214, FOC, FFF F0D: Error(C5900) FFE: Error(C5900)
• Description: An error was detected of the CU program.
• Remedy: Reinstall the CU board. Is the error message displayed again? After turn power OFF, check connections between CU board and PU board. Then turn power ON again.

• Code: 209
• Display: Power off/on 209:Download Error
• Description: Media Table download Error.
  Downloading Media Table to PU has failure.(Related to Custom Media Type)
• Remedy: Downloading Media Table to PU has failure.(Related to Custom Media Type) Turn the printer OFF/ON, and retry to download the PU firmware, again. (Usually, the procedure isn’t done, so this is not occur.)

• Code: 220
• Display: Service call 220:Error
• Description: False setting of a record medium detected by a print statistics.
• Remedy: Take off the HDD or replaced? Yes Reset original HDD.

• Code: 230
• Display: Service call 230:Error
• Description: RFID Reader not Installed
• Remedy: RFID read device error Is the error issued again?
  Check the connection of the RFID R/W board. Replace the RFID R/W board. Replace the S2V PCB.

• Code: 231
• Display: Service call 231:Error
• Description: RFID Reader I/F Error
  An interface error was detected with the RFID reader device. 01: communication error between the RFID reader and the engine PCB. 02: the transceiver circuit error of the RFID reader. 03: communication error between the RFID reader and the toner cartridge. 04: the toner cartridge detection error (more than 4).
• Remedy: 01: Same as Error 230 02: Replace RFID R/W board. 03: Check the antenna cable connection. 04: Check to see if the quantity of toner cartridge is correct.