Remedy: Either EEPROM or Flash ROM cannot read/write normally. Turn the printer power off and then back on. If the error symptom remains unchanged, replace the CU board.
Description: High voltage power supply interface error.
Remedy: Is the cable connecting the PU board to the high voltage unit connected normally? Have you checked defective contact of contactor points? Re-connect them normally. Check for defective contact of the high voltage system. Replace the high voltage power supply.
Remedy: Is the fan (bottom right of the front) of the low voltage power supply block working? Is the fan connector connected normally? Check for sure connection of the fan connector. Replace the PU board. Replace the fan motor. Replace the PU board.