Mã lỗi Panasonic UF6300 — Trang 3/11
Code:
Tất cả lỗi (82)
001
002
007
010
011
012
021
030
031
041
043
045
051
054
060
061
200
212
301
331
390
400
401
402
403
404
405
406
407
408
409
410
411
412
414
415
416
417
418
420
421
422
427
433
434
436
456
459
490
494
495
496
501
502
503
504
505
540
541
542
543
544
550
554
555
570
571
580
581
601
623
630
631
634
638
800
815
816
825
870
880
884
Description: Decoding process is not completed at the end of phase C.
Causes: Defective SC PCB.
Description: Interface error occurred between the CPU and modem.
Causes: Modem is defective. (SC PCB) Software problem occurred. (SC PCB)
Description: System fault.
Causes: Software problem occurred. (SC PCB)
Description: 8-minutes timer error. (Germany only)
Causes:
Description: Interface error occurred between the machine and the PC.
Causes: Firmware update error. GDI print error. (Perform the operation again)
Description: T1 timer (35±5 sec.) elapsed without detecting 300 bps signal.
Causes: Wrong number is dialed and the START button is pushed. Telephone line is disconnected while dialing. SC PCB (Modem) or MJR PCB are defective. Receiver is defective. (It may only be transmitting CED)
Description: DCN was returned from receiver while transmitter is waiting for CFR or FTT.
Causes: Your machine's ID Number is not programmed. Possible incompatibility or incorrect Password.
Description: DCN was returned from receiver while transmitter is waiting for NSF/DIS.
Causes: Receiver working in non-CCITT mode only. (Possible incompatibility)