Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 1045 — Trang 3/15

Code: 351

Description: ID sensor Vsg test error
When the ID sensor was checked, the ID sensor output voltage was 5.0V while the PWM signal input to the ID sensor was 0.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connection • I/O board (IOB) defective • Scanning system defective • High voltage supply board defective • ID sensor dirty • Defect at the ID sensor pattern writing area of the drum

Code: 352

Description: ID sensor, pattern edge detect error
The ID sensor pattern edge voltage is detected to be not 2.5V twice consecutively during an 800 ms interval.
Causes: • ID sensor defective • ID sensor connector defective • Poor ID sensor connector connection • I/O board (IOB) defective • High voltage supply board defective • Dirty ID sensor • Defect at the ID sensor pattern writing area of the drum

Code: 353

Description: ID sensor, LED current abnormal at initialization
• One of the following ID sensor output voltages is detected at ID sensor initialization. 1) Vsg < 4.0V when the maximum PWM input (255) is applied to the ID sensor. 2) Vsg >= 4.0V when the minimum PWM input (0) is applied to the ID sensor.
Causes: • ID sensor defective • ID sensor harness defective • ID sensor connector defective • Poor ID sensor connection • I/O board (IOB) defective • Exposure system defective • High voltage supply board defective • Dirty ID sensor

Code: 354

Description: ID sensor timeout abnormal at adjustment
Vsg falls out of the adjustment target (4.0 +- 0.2V) at the start of Vsg checking after 20 seconds
Causes: • ID sensor defective • ID sensor harness defective • ID sensor connector defective • I/O board (IOB) defective • Exposure system defective • Poor ID sensor connector connection • High voltage supply board defective • Dirty ID sensor

Code: 390

Description: TD sensor error: Test value abnormal
The TD sensor output voltage is less than 0.5V or more than 5.0V after 10 consecutive times during copying.
Causes: • TD sensor defective • TD sensor not connected or connector damaged • Poor connection between the TD sensor and the I/O board (IOB) • I/O board (IOB) defective • Toner supply defective

Code: 391

Description: TD sensor error: Auto adjust error
During automatic adjustment of the TD sensor, output voltage is less than 1.8V or more than 4.8V during TD sensor initial setting.
Causes: • TD sensor abnormal • TD sensor disconnected • Poor TD sensor connection • I/O board (IOB) defective • Toner supply defective

Code: 395

Description: Development output abnormal
A development bias leak signal is detected. High voltage output to the development unit exceeded the upper limit (65%) for 60 ms.
Causes: • High voltage supply board defective • Poor connection at the development bias terminal • Poor connection at the high voltage supply board

Code: 401

Description: Transfer roller leak detected
A transfer roller current leak signal is detected.
Causes: • High voltage supply board defective • Poor cable connection or defective cable • Transfer connector defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie