Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2022 — Trang 16/17

Code: 953

Description: Scanner setting error
The IPU does not respond with the scanner setting signal required to start scanning processing.
Causes: Download controller firmware

Code: 954

Description: Printer setting error
The IPU does not respond with the settings that are required to start image processing by the printer.
Causes: • Replace the IPU board • Replace the controller board • Download the controller firmware

Code: 955

Description: Memory setting error
The IPU does not respond with the settings that are required to start image processing using the memory.
Causes: • Replace the IPU board • Replace the controller board • Download the controller firmware

Code: 964

Description: Printer ready error
The printer ready signal is not generated within 17 seconds after the IPU received the print start signal.
Causes: • Replace the IPU board • Replace the controller board • Download the controller firmware

Code: 984

Description: Print image data transfer error
The image transfer from the controller to the engine via the PCI bus does not end within 15 s after starting.
Causes: • Controller board defective • SBCU board defective • Connectors between SBCU and controller loose or defective

Code: 986

Description: Software write parameter setting error
An unstable area at the storage destination in the settings table is set at NULL for the parameter received by the write module.
Causes: • Download controller firmware again

Code: 990

Description: Software performance error
The software attempted to perform an unexpected operation.
Causes: • Software defective • Internal parameter incorrect • Insufficient working memory • When this SC occurs, the file name, address, and data will be stored in NVRAM. This information can be checked by using SP7-403. Note the above data and the situation in which this SC occurs. Then report the data and conditions to your technical control center.

Code: 991

Description: Software continuity error
The software attempted to perform an unexpected operation. However, unlike SC990, the object of the error is continuity of the software.
Causes: • No operation required. This SC code does not appear on the panel, and is only logged.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie