Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2035e — Trang 17/18

Code: 985

Description: Scanner image data transfer error
The image transfer from the engine to the controller via the PCI bus does not end within 3 s after starting.
Causes: • Controller board defective • BICU defective • Connectors between BICU and controller loose or defective • SIB defective

Code: 986

Description: Software write parameter setting error
An unstable area at the storage destination in the settings table is set NULL for the parameter received by the write module.
Causes: • Software defective

Code: 990

Description: Software performance error
The software attempted to perform an unexpected operation.
Causes: • Software defective • Internal parameter incorrect • Insufficient working memory • When this SC occurs, the file name, address, and data will be stored in NVRAM. This information can be checked by using SP7-403. Note the above data and the situation in which this SC occurs. Then report the data and conditions to your technical control center.

Code: 991

Description: Software continuity error
The software attempted to perform and unexpected operation. However, unlike SC990, the object of the error is continuity of the software.
Causes: • Software bug • Internal parameter incorrect • Insufficient working memory

Code: 992

Description: Unexpected Software Error
Software encountered an unexpected operation not defined under any SC code.
Causes: • Software defective • An error undetectable by any other SC code occurred

Code: 995

Description: Machine Type Information Error
After the machine is powered on, a mismatch is detected between the CPM information sent from the controller to the engine and the CPM information specified by the DIP SW settings.
Causes: The B079 (35 cpm) and B082 (45 cpm) use the same controller board, but the DIP SW settings must be set correctly for the machine speed.

Code: 996

Description: FCU board error
FCU board is connected but not ready.
Causes: • FCU board defective and requires replacement • Firmware incorrect

Code: 997

Description: Application function selection error
The application selected by a key press on operation panel does not start or ends abnormally.
Causes: • Software defective • An option required by the application (RAM, DIMM, board) is not installed
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie