Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2238C — Trang 7/20

Code: 504-02

Description: Tray 4 error (3 Tray Paper Feed Unit)
When the main switch is turned or when the tray is set and if the upper limit is already detected, the lift motor turns on to lower the bottom plate until the lift sensor goes off. If the motor turns on for 7 seconds or more, the machine asks the user to reset the tray. If this condition occurs 3 consecutive times, this SC is generated.
Causes: • Defective tray lift motor or connector disconnection • Defective lift sensor or connector disconnection

Code: 530

Description: Fusing fan motor error
The BCU does not receive the lock signal (CN210-B5) 5 seconds after turning on the fusing fan.
Causes: • Defective fusing fan motor or connector disconnection • Defective BCU

Code: 541

Description: Heating roller thermistor error
The temperature measured by the heating roller thermistor does not reach 7 °C for ten seconds.
Causes: • Loose connection of the heating roller thermistor • Defective heating roller thermistor • Defective BCU

Code: 542

Description: Heating roller warm-up error
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 60 seconds during fusing unit warm-up.
Causes: • Heating roller fusing lamp broken • Defective heating roller thermistor • Defective BCU

Code: 543

Description: Heating roller fusing lamp overheat
The detected fusing temperature stays at 210°C or more for five seconds.
Causes: • Defective PSU • Defective BCU

Code: 544

Description: Heating roller fusing lamp high temperature error
During stand-by mode or a print job, the detected heating roller temperature stays at 210 °C or more for 0.2 second.
Causes: • Defective heating roller thermistor • Defective PSU • Defective BCU

Code: 545

Description: Heating roller fusing lamp consecutive full power
When the fusing unit is not running in the Ready condition, the heating roller fusing lamp keeps on with full power for 30 consecutive seconds.
Causes: • Heating roller thermistor out of position

Code: 546

Description: Heating roller fusing lamp temperature fluctuation
The heating roller temperature changes by ±20°C or more in one second. This occurs three times in one minute or two consecutive times.
Causes: • Loose connection of the thermistor • Loose connection between the fusing unit and main frame
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie