Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 250 — Trang 3/5

Code: SC411

Description: Separation bias error
A separation bias leak signal is detected.
Causes: • High voltage supply board defective • Poor connection of the PCU • Discharge brush defective

Code: SC500

Description: Main motor lock
A main motor lock signal is detected for more than 5 seconds or the lock signal is not detected for more than 500 ms during rotation.
Causes: • Too much load on the drive mechanism • Main motor defectivee

Code: SC503

Description: Upper tray lift motor malfunction (optional paper tray unit only)
The paper upper limit sensor is not activated after the tray lift motor has been on for 10 seconds.
Causes: • Upper limit sensor defective • Tray lift motor defective • IOCSS board defective for

Code: SC504

Description: Lower tray lift motor malfunction (optional paper tray unit only)
The paper upper limit sensor is not activated after the tray lift motor has been on for 10 seconds.
Causes: • Upper limit sensor defective • Tray lift motor defective • IOCSS board defective for

Code: SC506

Description: Paper tray unit main motor lock (optional paper tray unit only)
A main motor lock signal is detected for more than 5 seconds or the lock signal is not detected for more than 5 seconds during rotation.
Causes: • Paper tray unit main motor defective • Too much load on the drive mechanism

Code: SC542

Description: Fusing temperature warm-up error
The fusing temperature does not reach the fusing standby temperature within 50 seconds after the main switch is turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Fusing thermofuse open • Power supply board defective • Poor connection of the fusing unit

Code: SC543

Description: Fusing overheat error
A fusing temperature of over 231°C is detected for 1 second by the fusing thermistor.
Causes: • Fusing thermistor defective • Power supply board defective

Code: SC544

Description: Fusing low temperature error
A fusing temperature of lower 100°C is detected for 1 second by the fusing thermistor.
Causes: • Fusing thermistor defective • Power supply board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie