Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3245C — Trang 8/20

Code: 545

Description: Heating roller fusing lamp consecutive full power
When the fusing unit is not running in the Ready condition, the heating roller fusing lamp keeps on with full power for 35 consecutive seconds.
Causes: • Heating roller thermistor out of position

Code: 551

Description: Pressure roller thermistor error
The measured pressure roller temperature does not reach 7°C for 60 seconds.
Causes: • Loose connection of pressure roller thermistor • Defective pressure roller thermistor • Defective BCU

Code: 552

Description: Pressure roller warm-up error
After the main switch is turned on or the door is closed, the pressure roller temperature does not reach the ready temperature within 210 seconds during fusing unit warm-up.
Causes: • Pressure roller fusing lamp broken • Defective pressure roller thermistor • Defective BCU

Code: 553

Description: Pressure roller fusing lamp overheat
The detected pressure roller temperature stays at 210°C or more for five seconds.
Causes: • Defective PSU • Defective BCU

Code: 555

Description: Pressure roller fusing lamp consecutive full power
When the fusing unit is not running in the Ready condition, the pressure roller-fusing lamp keeps ON with full power for 300 consecutive seconds.
Causes: • Pressure roller thermistor out of position

Code: 560

Description: Zero cross error
When the main switch is turned on, the machine checks how many zero-cross signals are generated during 500 ms. If the number of zero-cross signal generated is either more than 66 or less than 45 and when this condition is detected 10 consecutive times, this code is displayed.
Causes: • Electrical noise in the supply from the power cord

Code: 620

Description: ARDF communication error
• After the ARDF is detected, the break signal occurs or communication timeout occurs.
Causes: • Incorrect installation of ARDF • ARDF defective • IPU board defective • External noise

Code: 621

Description: Two-tray finisher/booklet finisher communication error
Causes: • Cable problems • BCU problems • PSU problems in the machine • Main board problems in the peripherals
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie