Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3260C — Trang 20/31

Code: SC555

Description: Pressure roller thermistor error 5: Lamp remains on
After hot roller reaches warmup temperature, the pressure roller fusing lamp remains for 6 sec. while the hot roller is not rotating.
Causes: • Thermistor damaged, or out of position • Fusing lamp disconnected, broken

Code: SC556

Description: Heating roller thermistor 2 error 5: Lamp remains on
After hot roller reaches warmup temperature, the pressure roller fusing lamp remains for 6 sec. while the hot roller is not rotating.
Causes: • Thermistor damaged, or out of position • Fusing lamp disconnected, broken

Code: SC561

Description: Hot roller thermistor error 1: Thermistor disconnected
The temperature measured by the hot roller thermistor does not reach the prescribed warm-up temperature within 100 sec.
Causes: • Loose connection of the hot roller thermistor • Defective hot roller thermistor • Defective BCU

Code: SC562

Description: Hot roller thermistor error 2: Failure to reach warmup temperature
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 2 sec. after the heater switches on. -or- If the roller was below 45°C, the heating roller did not reach the ready temperature 2 sec. after reaching 45°C. Note: Thermistor 2 stops monitoring the temperature once Thermistor 1 detects ready temperature.
Causes: • Hot roller fusing lamp broken • Defective hot roller thermistor • Defective BCU

Code: SC563

Description: Hot roller thermistor error 3: Software - High Temperature
The thermistor detected a temperature over 250°C 10 times within 1 sec.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC564

Description: Hot roller thermistor error 4: Hardware - High Temperature
The thermistor detected a temperature over 260°C.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC565

Description: Hot roller thermistor error 5: Lamp remains on
After hot roller reaches warmup temperature, the hot roller fusing lamp remains for 6300 sec. while the hot roller is not rotating.
Causes: • Thermistor damaged, or out of position • Fusing lamp disconnected, broken

Code: SC620

Description: ARDF communication error
A BREAK signal occurs after the machine detects the ARDF, or a communication timeout occurs.
Causes: • ARDF disconnected • IPU board harness disconnected, defective • IPU board defective • Spurious noise from the power supply line • ARDF control board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie