Mã lỗi Ricoh Aficio 550 — Trang 3/7
Code:
Tất cả lỗi (52)
SC101
SC120
SC121
SC190
SC191
SC302
SC303
SC305
SC320
SC321
SC322
SC323
SC325
SC350
SC360
SC361
SC390
SC391
SC392
SC401
SC405
SC440
SC490
SC501
SC502
SC503
SC504
SC506
SC507
SC521
SC524
SC541
SC542
SC543
SC545
SC546
SC547
SC600
SC601
SC602
SC604
SC605
SC620
SC621
SC623
SC625
SC720
SC721
SC722
SC723
SC724
SC900
Description: TD sensor error
TD sensor output voltage falls out of the adjustment target (2.5+- 0.1 V) during the Vt check.
Vt-Vtref>0.6V is detected 10 consecutive times even though toner is detected by the toner end sensor.
Vt<0.5 or Vt>4.0 is detected.
Causes: • TD sensor abnormal • BCU board defective
Description: Development bias leak
A development bias leak signal is detected.
Causes: • Sleeve roller receptacle damage • Development bias power pack defective
Description: Image storage address error
The EX-IPU receives the image data output request signal for data that is not stored in memory
Causes: • Transfer high voltage supply board defective • Transfer belt position sensor defective
Description: Transfer belt error
A transfer belt current leak signal is detected.
Causes: • Transfer high voltage supply board defective • Transfer belt position sensor defective
Description: Time out error (scanner)
The BCU does not receive the scanner access ready signal from the EX-IPU
Causes:
Description: Main motor lock
A main motor lock signal is detected for more than 2 seconds.
Causes: • Too much load on the drive mechanism • Main motor defective
Description: Ozone fan motor lock/Exhaust fan motor lock
A fan motor lock signal is detected for more than 0.5 second from either fan.
Causes: • Ozone fan motor defective • Exaust fan motor defective • Poor connection of the fan motor connector • Something is stuck in the fan motor
Description: Main body tray lift motor malfunction
• The paper upper limit sensor is not actuated after the tray lift motor has been on for 10 seconds. • The pick-up roller solenoid does not contact the top sheet of paper
Causes: • Upper limit sensor defective • Tray lift motor defective • Pick-up roller solenoid defective