Description: Fusing temperature warm-up error
The fusing temperature does not reach the fusing standby temperature within 135.0 seconds after the main switch is turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Fusing thermofuse open • BCU board defective • AC drive board defective
Description: Fusing overheat error 2
The fusing lamp stays on at full power for 30.0 seconds while in the stand-by condition after warm-up is completed.
Description: Fusing ready temperature malfunction
The fusing temperature goes 20 °C below or 20 °C over the stand-by temperature after warm-up is completed.
Causes: • Poor thermistor connection • Poor connection of the sliding connector between the fusing unit and the rear of the machine