Description: Tray 2 lift motor malfunction (Optional paper tray unit)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for
18 seconds.
Causes: • Paper lift sensor defective
• Tray lift motor defective
• Too much load on the drive mechanism
• Poor tray lift motor connection
Description: Tray 3 lift motor malfunction (optional paper tray unit)
The paper lift sensor fails to activate twice continuously after the tray lift motor has been on for 18 seconds.
Causes: • Paper lift sensor defective
• Tray lift motor defective
• Too much load on the drive mechanism
• Poor tray lift motor connection
Description: Paper feed motor lock (optional paper tray unit)
A motor lock signal is not detected for more than 1.5 s or the lock signal is not detected for more than 1.0 s during rotation.
Causes: • Paper feed motor defective
• Too much load on the drive mechanism
Description: Fusing thermistor open (center)
The fusing temperature detected by the thermistor is below 71°C and is not corrected after the main power switch is turned on.
Causes: • Fusing thermistor defective or out of position
• Power supply board defective
• Loose connectors
Description: Fusing temperature warm-up error (center)
The fusing temperature rises less than 9 degrees in 3 seconds, and this continues 5 times consecutively. The fusing temperature is not detected in 90 seconds after turning on the fusing lamp.
Causes: • Fusing thermistor defective or out of position
• Fusing lamp open
• Power supply board defective
Description: Fusing overheat error (center)
The fusing temperature is over 230°C and continues 10 times consecutively. (100ms x 10 = 1
second). (detected by the thermistor).
Causes: • Fusing thermistor defective
• Power supply board defective
Description: Fusing overheat error (center) 2
The fusing temperature is over 250°C and continues 10 times consecutively. (100ms x 10 = 1 second). (detected by the fusing temperature monitor circuit).
Causes: • Fusing thermistor defective
• Power supply board defective
Description: Fusing lamp overheat error (center)
After the fusing temperature reaches the target temperature, the fusing lamp does not turn off for 15 consecutive seconds.
Causes: • Fusing thermistor defective or out of position
• Power supply board defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.