Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP1812L — Trang 4/6

Code: 546

Description: Unstable fusing temperature (center)
The fusing temperature varies 50° C or more within 1 second, and this occurs 2 consecutive times.
Causes: • Thermistor defective or out of position
• Power supply unit defective

Code: 547

Description: Zero cross signal malfunction
Zero cross signals are not detected within 5 seconds after the main power switch is turned on, or are not detected within 1 second after operation begins.
Causes: • Power supply board defective
• BICU defective

Code: 559

Description: Jam error detected 3 times in succession
The exit sensor and the duplex sensor detect a paper jam 3 times in succession This condition can occur when SP 1159 1 is set to ‘on’. The default is ‘off’.
Causes: Paper jams can occur for the following reasons.
• Dampness
• Paper curl
• Incorrect paper setting in the paper tray
• Stripper pawls coming apart

Code: 590

Description: Left exhaust fan motor error
The CPU detects an exhaust fan lock signal for more than 5 seconds.
Causes: • Loose connection of the exhaust fan motor
• Too much load on the motor drive

Code: 591

Description: Rear exhaust fan motor error
The CPU detects an exhaust fan lock signal for more than 5 seconds.
Causes: • Loose connection of the exhaust fan motor
• Too much load on the motor drive

Code: 620

Description: Communication error between BICU and ADF
The BICU does not receive a response from the ADF main board for 4 seconds or more. The BICU receives a break signal from the ADF main board.
Causes: • Poor connection between the BICU and
ADF main board (DF connector)
• ADF main board defective
• BICU defective

Code: 621

Description: ADF connection error
An incorrect ADF (an ADF for some other copier) is detected.
Causes: • ADF incorrect (The ADF for B039/B040/ B043 or B121/B122/B123/B259/ B260/B261 is installed on a B282/B283)
• The connector of the ADF is removed while the machine is in the energy saver mode

Code: 692

Description: Controller board communication abnormal
Communication error between the printer part of the controller board and BICU.
Causes: • The connector is abnormal between the controller board and the BICU board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie