Description: 4th paper tray lift motor malfunction (optional Paper Tray Unit) The paper lift sensor did not activate within 18 sec. after the tray lift motor switched on.
Causes: • An obstruction (jammed paper, paper scraps, etc.) has blocked the motor drive and caused an overload. • Paper lift sensor connection loose, disconnected, or damaged • Paper lift sensor defective • Tray lift motor connection loose, disconnected, or damaged • Tray lift motor defective
Description: Paper tray motor lock (optional Paper Tray Unit) A motor lock signal is not detected for more than 1.5 s or the lock signal is not detected for more than 1.0 s during rotation.
Causes: • An obstruction (jammed paper, paper scraps, etc.) has blocked the motor drive and caused an overload. • Paper tray motor connection loose, disconnected, or damaged • Paper tray motor defective
Description: LCT rear fence drive error The return position sensor is not activated after the rear fence drive motor has been on to lower the tandem tray for 8 seconds.
Causes: • An obstruction (jammed paper, paper scraps, etc.) has jammed the rear fence or motor • Rear fence motor connection loose, disconnected, or damaged • Rear fence motor defective • Return position sensor connector loose, disconnected, or damaged • Return position sensor defective
Description: LCT side fence drive error The side fence positioning sensor is not activated for more 3 seconds when the paper stack in the left tray is moved to the right tray. The side fence close sensor is not activated for more 3 seconds after moving the paper stack to the right tray.
Causes: • An obstruction (jammed paper, paper scraps, etc.) has jammed the rear fence or motor • Side fence motor disconnected or defective • Side fence position sensor disconnected or defective Side fence close sensor disconnected or defective
Description: LCT lower limit error The lower limit sensor does not activate within 8 seconds after the tray has been lowered.
Causes: • An obstruction (jammed paper, paper scraps, etc.) has jammed the tray lift motor • Tray lift motor defective • Poor connection of the tray lift motor • Lower limit sensor disconnected or defective Obstruction that causes overload on the drive mechanism.
Description: Fusing thermistor open (center) The temperature of the hot roller remained below 0C for 5 sec at the center of the hot roller.
Causes: • Fusing thermistor out of its position because of incorrect installation • Fusing thermistor disconnected or defective • Power supply not within rated range (15% or more below rating)
Description: Fusing temperature warm-up error (center) The fusing temperature did not reach the standby temperature within 20 sec. at the center of the hot roller after the main switch turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp disconnected • Thermistor defective • Fusing lamp defective
Description: Fusing overheat error 1 (center) The fusing thermistor detected a fusing temperature over 230 °C for 5 sec. at the center of the hot roller.
Causes: • TRIAC short on PSU (PSU defective) • BCU board defective • Fusing thermistor defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.