Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4000B — Trang 11/21

Code: 650-012

Description: Communication error of the remote service modem (Embedded RCG-M): Modem board error
The modem board does not work properly even though the setting of the modem board is installed with a dial up connection.
Causes: • Same as -001 1. Install the modem board. 2. Check and reset the modem board setting with SP5816. 3. Replace the modem board.

Code: 651-001

Description: Incorrect dial up connection: Program parameter error
An unexpected error occurs when the modem (Embedded RCG-M) tries to call the center with a dial up connection.
Causes: • Caused by a software bug

Code: 651-002

Description: Incorrect dial up connection: Program execution error
An unexpected error occurs when the modem (Embedded RCG-M) tries to call the center with a dial up connection.
Causes: • Caused by a software bug

Code: 669

Description: EEPROM error
Retry of EEPROM communication fails three times after the machine has detected the EEPROM error.
Causes: • Caused by noise

Code: 670

Description: Engine startup error
The BICU fails to respond with the prescribed time when the machine is turned on.
Causes: • Connections between BICU and controller board are loose, disconnected, or damaged 1. Replace the BICU 2. Replace the controller board

Code: 671

Description: BICU error
The model code from the BICU is not correct when the machine is turned on.
Causes: Install the correct BICU for this model.

Code: 672

Description: Controller-to-operation panel communication error at startup
• After the machine is powered on, the communication between the controller and the operation panel is not established, or communication with controller is interrupted after a normal startup. • After startup reset of the operation panel, the attention code or the attention acknowledge code is not sent from the controller within 15 seconds. • After the controller issues a command to check the communication line with the controller at 30-second intervals, the controller fails to respond twice.
Causes: • Controller stalled • Controller board installed incorrectly • Controller board defective • Operation panel connector loose or defective • The controller is not completely shutdown when you turn the main switch off. Check the setting of SP5875-001. If the setting is set to "1 (OFF)", change it to "0 (ON)".

Code: 687

Description: Memory address (PER) command error
The BICU does not receive a memory address command from the controller for the prescribed time after the paper has reached the registration sensor.
Causes: • Harness Disconnection at BICU • Controller board loose or broken • Defective BICU • Defective Controller Board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie