Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4002 — Trang 19/24

Code: 835

Description: Self-diagnostic error: Centronic device
Causes: [1102] Loopback connector is connected but check results in an error. • IEEE1284 connector error • Centronic loopback connector defective Replace the controller board. [110C] Loopback connector is connected but check results in an error. • ASIC device error • IEEE1284 connector error • Centronic loopback connector defective Replace the controller board. [1120] Centronic loopback connector is not connected for detailed self-diagnostic test. • Centronic loopback connector not connected correctly • Centronic loopback connector defective • ASIC device defective Replace the controller board.

Code: 838

Description: Self-diagnostic Error: Clock Generator
Causes: [2701] A verify error occurred when setting data was read from the clock generator via the I2C bus. • Defective clock generator • Defective I2C bus • Defective I2C port on the CPU Replace the controller board.

Code: 839

Description: USB NAND Flash ROM error
EEPROM error 1: EEPROM access
Causes: [9001] USB NAND Flash ROM cannot be read. • Defective controller board [9101] The ID of the USB NAND Flash ROM cannot be read. • Defective controller board [9110] The USB NAND Flash ROM controller is disconnected. • Defective controller board

Code: 840

Description: During the I/O processing, a reading error occurred. The 3rd reading failure causes this SC code. During the I/O processing, a writing error occurred
Causes: Defective EEPROM

Code: 841

Description: EEPROM error 2: EEPROM read/write error
Mirrored data of the EEPROM is different from the original data in EEPROM.
Causes: Data in the EEPROM is overwritten for some reason.

Code: 842

Description: Flash ROM verification error
Verification error of the flash ROM on the controller board occurs
This SC is logged at 1st error detection.SC819 is issued at 2nd error detection.
SC819 is issued at 2nd error detection
Causes: Defective flash ROM (controller board)

Code: 851

Description: IEEE 1394 I/F error
Driver setting incorrect and cannot be used by the 1394 I/F.
Causes: Not supported by this machine • NIB (PHY), LINK module defective; change the Interface Board Controller board defective

Code: 853

Description: Wireless LAN Error 1
During machine start-up, the machine can get access to the board that holds the wireless LAN, but not to the wireless LAN card (Bluetooth).
Causes: • During machine operation, the Wireless LAN device (Bluetooth) is inserted into the controller board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie