Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4002SP — Trang 4/24

Code: 351

Description: ID sensor Vsg test error
When the ID sensor was checked, the ID sensor output voltage is 5.0V while the LED current value is 0.
Causes: • ID sensor defective or dirty • ID sensor connector defective • Poor ID sensor connection • I/O board (IOB) defective • Scanning system defective • High voltage supply board defective • Defect at the ID sensor pattern writing area of the drum

Code: 355

Description: Grayscale measurement error
When the grayscale control result is the maximum and it does not operate correctly and these cases are detected 15 times.
Causes: • ID sensor defective or dirty • The life of ID sensor or photo conductor • Shield glass dirty

Code: 360

Description: TD sensor (Vt) error 1
The following condition occurs thirty times consecutively during printing. Vt is less than 0.5V or 4.8V or more
Causes: • TD sensor disconnected • Harness between TD sensor and PCDU defective • Defective TD sensor.

Code: 372

Description: TD sensor adjustment error
Vts is less than 1.8V or 4.8V or more during TD sensor initialization.
Causes: • Heat seal not removed from a new developer pack • TD harness sensor disconnected, loose or defective • TD sensor defective • Harness between TD sensor and drawer disconnected, defective

Code: 396

Description: Drum motor error
The machine detects a lock signal error from the drum motor for 2 seconds after the drum motor turned on.
Causes: • Overload on the motor • Defective drum motor • Defective harness • Defective IOB

Code: 400

Description: Vsg adjustment error
Vsg is more than 4.2V or 3.8V or less when the machine adjusts Vsg value.
Causes: • Dirty or defective ID sensor • Defective ID sensor shutter

Code: 440

Description: Transfer belt bias error
The feed back bias from the transfer belt is more than 4V for 60 msec while the transfer belt bias is output. The A/D conversion level is 20 or less for 60 msec. The PWM duty is 24% or more for 60 msec.
Causes: • Power pack broken • Defective harness • Disconnected connector

Code: 441

Description: Transfer/Development motor error
The machine detects a lock signal error from the transfer/development motor for 2 seconds after the transfer/development motor turned on.
Causes: • Overload on the motor • Defective transfer/development motor • Defective harness • Defective IOB
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie