Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4054 — Trang 9/40

Code: SC530-00

Description: Fusing Fan Lock In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the fusing fan. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC531-00

Description: Development Bearing Cooling Fan Lock. In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the development bearing cooling fan • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC533-00

Description: PSU Cooling Fan Lock. In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the development bearing cooling fan. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC533-01

Description: Development Bearing Cooling Fan In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the development bearing cooling fan. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC534-00

Description: Development Exhaust Fan. In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the development exhaust fan. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC535-00

Description: Paper Exit Cooling Fan Lock In the motor ON state, the value of the lock sensor is checked every 100msec. If a lock signal is not obtained for 50 times consecutively.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective
Remedy: • Replace the paper exit cooling fan. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC540-00

Description: Fusing/paper Exit Motor: Lock During motor ON, after checking lock signals for 2sec, a High level was detected at least 20 times.
Causes: • Motor defective • Connector disconnected • Harness broken • IOB defective • Unit torque increased
Remedy: • Replace the fusing/paper exit motor. • Reset the connector. • Replace the harness. • Replace the IOB.

Code: SC541-01

Description: Fusing Central Thermopile Disconnection Below a predetermined temperature (or below CB) is detected for specified seconds continuously. Detection frequency: 10 times or more.
Causes: • Disconnection • Connector disconnected
Remedy: • Replace the thermopile. • Reset the connector. • Replace the connector.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie