Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP4500 — Trang 9/18

Code: 632

Description: Key/card counter device error 1
After 1 data frame is sent to the device, an ACK signal is not received within 100 ms, and is not received after 3 retries.
Causes: • The serial line from the device to the copier is unstable, disconnected, or defective.

Code: 633

Description: Key/card counter device error 2
During communication with the device, the BCU received a break (Low) signal.
Causes: • The serial line from the device to the copier is unstable, disconnected, or defective.

Code: 634

Description: Key/card counter device error 3
The backup battery of the counter device RAM is low.
Causes: • Replace the RAM backup battery.

Code: 635

Description: Key/card counter device error 4
After installation of the device a message alerts user to a battery voltage abnormal error.
Causes: • Device control board defective • Device control board backup battery defective

Code: 640

Description: BICU-to-Controller Data Transfer Error 1: Sum Check Error
The system detected an error during sum check for data transfer from the BICU to the controller board. Note: This error is simply logged and the machine does not return an error number on the display.
Causes: • No action required • The log count increments by one for every error

Code: 641

Description: BICU-to-Controller Data Transfer Error 2: Frame Error
The system detected an error after data was sent from the BICU to the controller board.
Causes: • No action required • The log count increments by one for every error

Code: 670

Description: Engine startup error
The BCU failed to respond with the prescribed time when the machine was turned on.
Causes: • Connections between BCU and controller board are loose, disconnected, or damaged • Replace the BCU • Replace the controller board

Code: 672

Description: Controller startup error
• After power on, the line between the controller and the operation panel did not open for normal operation. • After normal startup, communication with the controller stopped.
Causes: • Controller stalled • Controller installed incorrectly • Controller board defective • Operation panel harness disconnected or defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie