Code :

Code: 722-72
Description: Front shift jogger motor error (D610) The sides fences do not retract within the prescribed time after the shift jogger motor switches on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Shift jogger motor disconnected, defective • Shift jogger motor overloaded due to obstruction • Shift jogger HP sensor disconnected, defective

Code: 722-74
Description: Shift jogger retraction motor error (D610) The side fences do not retract within the prescribed time after the retraction motor switches on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Motor defective • Motor overload • HP defective

Code: 722-75
Description: Return roller motor error (D610) Occurs during the operation of the lower tray pressure motor.
Causes: • Motor harness disconnected, loose, defective • Motor overloaded • Home position sensor harness disconnected, loose, defective • Home position defective

Code: 722-80
Description: Finisher staple trimming hopper full (D610) The staple waste hopper is full of cut staples.
Causes: • If the hopper is full, empty the hopper • If the hopper is not full, the hopper full sensor is disconnected, defective

Code: 722-81
Description: Finisher transport motor error (D610) The encoder pulse of the finisher transport motor does not change state (high/low) within 600 ms and does not change after 2 retries.
Causes: • Finisher transport motor defective • Transport motor harness disconnected, or defective • Finisher main board defective

Code: 722-83
Description: Finisher punch motor error (D610) The punch HP sensor is not activated within the specified time after the punch motor turned on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Punch HP sensor disconnected, defective • Punch motor disconnected, defective • Punch motor overload due to obstruction

Code: 724-71
Description: Shift Motor Error The shift tray half-turn sensors: Failed twice to detect the shift tray at the home position at the specified time. -or- Failed twice to detect that the shift tray had left the home position.
Causes: If the motor is operating • Half-turn sensor 1, 2 harnesses loose, broken, defective • One of the half-turn sensors is defective If the motor is not operating: • Motor blocked by an obstruction • Motor harness loose, broken, defective • Motor defective • Finisher main board defective

Code: 725-01
Description: Downstream finisher communication error (D615) No response signal was received from the downstream finisher (D615) after 3 attempts
Causes: • Finisher I/F cable loose, broken defective • Finisher control board defective