Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP7000SP — Trang 17/25

Code: 754

Description: Z-Folding unit error 4 B140
2000 ms after the fan motor switched on, the lock signal did not release.
Causes: • Fan motor defective
• Fan motor disconnected
• Fan motor locked because of too much load
• Z-Fold main control board defective

Code: 754

Description: Z-Fold Unit Fan Motor Error B246
The motor lock signal failed to release within 2 sec. after the Z-fold unit fan motor turned on.
Causes: • Fan motor connected loose, broken defective
• Fan motor defective
• Fan blocked by an obstruction

Code: 755

Description: Z-Folding unit error 5 B140
The fold timing sensor does not operate correctly.
Causes: • Paper dust on the sensor
• Sensor disconnected, defective
• Reflector plate dirty, or out of position
• Z-Fold main control board defective

Code: 756

Description: Z-Folding unit error 6
The leading edge sensor does not operate correctly.
Causes: • Paper dust on the sensor
• Sensor disconnected, defective
• Reflector plate dirty, or out of position
• Z-Fold main control board defective

Code: 757

Description: Z-Folding unit error 7
The machine could not write to the EEPROM two times (one after the other).
Causes: • EEPROM defective, replace Z-Fold main control board

Code: 760

Description: Finisher punch motor error
The punch HP sensor is not activated within the specified time after the punch motor turned on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Punch HP sensor disconnected, defective
• Punch motor disconnected, defective
• Punch motor overload due to obstruction

Code: 761

Description: Finisher folder plate motor error
The folder plate moves but is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Folder plate HP sensor disconnected, defective
• Folder plate motor disconnected, defective
• Folder plate motor overloaded due to obstruction.

Code: 762

Description: Finisher pressure plate motor error
Pressure plate motor operating but the plate is not detected at the home position within the specified time. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Pressure plate HP sensor disconnected, defective
• Pressure plate motor disconnected, defective
• Pressure plate motor overloaded due to obstruction
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie