Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP9000 — Trang 8/25

Code: SC439

Description: Drum Potential Sensor Error 6: Vh Abnormal
When the LD power was adjusted during auto process control, the first value detected for the Vh pattern (used to set standard drum potential for halftones) exceeded -730V
Causes: • Drum potential sensor harness, connector loose, broken, defective
• Drum potential sensor defective
• LD unit defective (pattern could not be created)

Code: SC440

Description: Transfer Output Error
One of the following conditions was detected for 17 counts (about 100 ms) when the transfer voltage was applied with the main motor operating:
• The value for the transfer current was set for 70uA, but the feedback voltage was less than 0.75V (less than 1.5 KV).
• When the feedback current was less than 0.16V (10uA), the feedback voltage was less than 0.15V (less than 300V) due to a poor input connection.
• When the feedback current was less than 0.16V (10uA), the feedback voltage was less than 3.05V (over 6.1 KV) due to a poor output connection.
Causes: • Transfer power pack harness, connectors loose or broken
• Transfer power pack harness or connectors have short circuited
• Transfer power pack is defective

Code: SC441

Description: Development Motor Lock
While the motor is operating, the motor lock signal remained LOW for 2 s
Causes: • Development motor lock due to overload
• IOB defective

Code: SC487

Description: Toner Collection Unit Lock
The toner collection coil rotation sensor did not detect rotation of the coil within 5 s after the drum motor turned on due to toner clumping in the collection unit.
Causes: • Cycle the machine off/on
• Empty or replace the toner collection bottle.

Code: SC488

Description: 2nd Cleaning Blade Operation Error
The push-switch signal from the cleaning blade solenoid was incorrect. The signal is detected 1 sec. after the solenoid operates.
Causes: • 2nd blade solenoid connector loose, broken defective
• 2nd blade solenoid defective
• Release mechanism defective

Code: SC489

Description: Drum Cleaning Unit Set Error
The drum cleaning unit is not set properly. The drum cleaning unit set switch is set every time the machine is turned on and when the front doors are closed.
Causes: 1. Remove the drum cleaning unit
2. Install it again.
3. Close the front doors
4. Cycle the machine off/on

Code: SC491

Description: Polygonal Mirror Motor Cooling Fan Motor Lock
The polygonal mirror motor cooling fan motor lock signal remains HIGH for 5 s while the polygonal mirror motor cooling fan motor is on.
Causes: • Drive mechanism overload
• Obstruction has stopped the fan
• Fan connector loose, broken, defective

Code: SC492

Description: Development Unit Suction Motor Lock
While the development unit toner suction motor is operating, the lock sensor output did not change for 1 s An electrical overload in the PCB inside the motor unit has caused the motor to malfunction.
Causes: • Replace the motor
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie