Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC3003SP — Trang 41/45

Code: SC878-02

Description: TPM error Error occurred in the TPM or TPM driver.
Causes: TPM defective
Remedy: Replace the controller board.

Code: SC878-03

Description: TCSD error Error occurred in TPM software stack.
Causes: • Unable to start TPM • Necessary files missing from the TPM.
Remedy: Replace the controller board.

Code: SC880-00

Description: MLB error Reply to MLB access was not returned within a specified time.
Causes: MLB defective
Remedy: • Replace the MLB. • Remove the MLB.

Code: SC881-01

Description: Authentication area error • Software error detected. • This error may occur even if IC card option (ERIE/AYU/Greenland etc.) is not installed.
Causes: • This is caused by accumulation of abnormal authentication information in the software. (User operation will not directly cause it.) • Occurs when authentication is done. Example: When a job is sent to the printer/when logged on from the operation panel/when logged on from a Web browser
Remedy: Turn the main power off/on.

Code: SC882-01

Description: Cheetah Operation Panel error (Cheetah Operation Panel Software Invalid error) Occurs when the validity of the operation unit is not observed.
Causes: • Memory corruption of the operation panel software. • Invalid applications are listed in the operation panel.
Remedy: • Format the Operation panel through SP mode • Updating the firmware

Code: SC899-00

Description: Software performance error (signal reception end)
Causes: Occurs when an internal program behaves abnormally.
Remedy: In case of a hardware defect • Replace the hardware. In case of a software error • Turn the main power off/on. • Try updating the firmware.

Code: SC900-00

Description: Electric counter error The electric total counter value is out of specification. Error is detected when increasing the total counter.
Causes: • Unexpected NV-RAM is attached. • NV-RAM defective • NV-RAM data corrupted. • Data written to unexpected area because of external factor etc. • The count requested by the SRM on receiving PRT is not completed.
Remedy: Replace the NV-RAM.

Code: SC910-00

Description: External Controller Error 1 Notification from external application (external controller)
Causes: Subject to external application (external controller) specification
Remedy: Turn the main power off/on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie