Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MPC6501 — Trang 3/44

Code: SC185

Description: CIS communication error Error
caused during ASIC register's automatic initialization on the CIS, or during transmission between the CIS - DF.
Causes: • Harness between the CIS - DF is disconnected • CIS defectiver

Code: SC186

Description: CIS LED error
LED on the CIS caused an error • During initializing, the ratio of the average between leading-edge area and rear-edge is out of range (0.7 to 1.43). • During scanning, the shading data peak is under 32 (8 bit).
Causes: • Harness CN210 and CN220 on ADF are disconnected. • Replace CIS.

Code: SC187

Description: CIS black level error
The black level scanned by CIS is abnormal. The black level average of R, G or B is not within range (2 to 62). 0 < Calibrated Black data level < 255(10bit).
Causes: • Turn off the machine. • Make sure CN210 and CN220 are connected securely. • Turn on the machine.

Code: SC188

Description: CIS white level error
The shading data peak detected from the CIS is abnormal.
Causes: • CIS defective

Code: SC189

Description: CIS gray balance adjustment error The adjustment error occurs during the test after adjusting the gray balance
Causes: • CIS defective

Code: SC195

Description: Machine serial number error
The number registered for the machine serial number does not match.
Causes: • Confirm the correct serial number of the machine in the specifications • Important: When SC195 occurs, the serial number must be input. Please contact your technical supervisor.

Code: SC202

Description: Polygon motor error: ON timeout
The polygon mirror motor does not reach the targeted operating speed within the prescribed time
Causes: • Harness to polygon motor drive board disconnected, defective • Polygon motor defective • Polygon motor drive board defective • Polygon motor defective.

Code: SC203

Description: Polygon motor error: OFF timeout
The polygon mirror motor does leave the READY status within 3 seconds after the polygon motor switches off.
Causes: • Harness to polygon motor driver board disconnected, defective • Polygon motor defective • Polygon motor driver board defective • Polygon motor defective.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie