Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP8300DN — Trang 5/20

Code: 533

Description: Paper exit cooling fan motor error The machine does not detect the fan motor lock signal for 10 seconds after turning on the paper exit cooling fan motor.
Causes: • Defective paper exit cooling fan motor or connector disconnection. • Defective IOB • Disconnected harness
Remedy:

Code: 540

Description: Fusing motor error The IOB does not receive the lock signal for 2 seconds after turning on the fusing motor.
Causes: • Motor overload • Defective fusing motor or connector disconnection. • Defective IOB • Disconnected harness
Remedy:

Code: 541

Description: Fusing thermistor open (center) The thermistor (center) detects 0°C or less for 16 sec. in a row.
Causes: • Fusing thermistor disconnected • Fusing thermistor connector defective
Remedy:

Code: 542

Description: Fusing temperature warm-up error(center) This SC is generated if the following condition occurs: • The thermistor (center) does not detect an 8°C increment in the fusing temperature for 1.5 sec. just after the fusing temperature reached 45°C. • The temperature of the center thermistor does not reach 60°C for 7 seconds after the fusing lamps turned on. • The temperature of the center thermistor does not reach the target temperature for 26 seconds after the fusing lamps turned on.
Causes: • Thermistor warped or broken • Input voltage is unwarranted
Remedy:

Code: 543

Description: Fusing overheat error 1 (software detection) A fusing temperature (at the center) of over 230°C (446°F) is detected for 1 second by the fusing thermistors at the center or at either end of the fusing roller.
Causes: • Power supply unit defective • I/O board (IOB) defective • BCU defective • TRIAC short on PSU (PSU defective)
Remedy:

Code: 544

Description: Fusing overheat error 1 (hardware detection) A fusing temperature (at the center) over 250°C is detected by the fusing temperature monitor circuit in the BCU board.
Causes: • I/O board (IOB) defective • BCU defective • TRIAC short on bridge board (bridge board defective)
Remedy:

Code: 545

Description: Fusing lamp consecutive full power 1 After warm-up the fusing lamp remains at full power for 10 seconds without the hot roller rotating.
Causes: • Thermistors (center) warped • Disconnected or defective thermistors (center) • Defective fusing lamp
Remedy:

Code: 547

Description: Zero cross error • The zero cross signal is detected three times even though the heater relay is off when turning on the main power. • The zero cross signal is not detected for 2 seconds even though the heater relay is on after turning on the main power or closing the front door. • The detection error occurs twice or more in the 11 zero cross signal detections. This error is defined when the detected zero cross signal is less than 45.
Causes: • Defective fusing lamp relay • Defective fusing lamp relay circuit • Unstable power supply
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie