Description: Communication error of the remote service modem (Embedded RCG-N). Communication line error The supplied voltage is not sufficient due to a defective communication line or defective connection.
Causes: • Incorrect SP settings • Disconnected telephone line • Disconnected modem board Consult with the user's local telephone company.
Description: Communication error of the remote service modem (Embedded RCG-N). Modem board error 2 The modem board is installed even though the RCG-N is installed.
Causes: • Disconnect the Wireless LAN or Ethernet LAN board 1. Uninstall the modem board, if it is installed. 2. Check that the Wireless LAN or Ethernet LAN is working properly.
Description: Incorrect dial up connection -01: Program parameter error -02: Program execution error. An unexpected error occurs when the modem (Embedded RCG-M) tries to call the center with a dial up connection.
Description: ID2 mismatching ID2 for @Remote certification is mismatching between the controller board and NVRAM. • Used controller board installed • Used NVRAM installed
Causes: An unexpected error occurs when the modem (Embedded RCG-M) tries to call the center with a dial up connection. 1. Install the correct controller board or new controller board. 2. Install the correct NVRAM or new NVRAM.
Description: ID2 error ID2 stored in the NVRAM is incorrect.
Causes: • Used NVRAM installed
Remedy: An unexpected error occurs when the modem (Embedded RCG-M) tries to call the center with a dial up connection. Clear the ID2 in the NVRAM, and then input a correct ID2.