Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SPC831DN — Trang 14/24

Code: 569-01

Description: Fusing shutter sensor error
Fusing shutter plate home position sensor error is detected three consecutive times.
Causes: Defective fusing shutter plate. Defective photo interrupter. Defective connectors.
Remedy:

Code: 571

Description: Pressure roller thermistor error: Center
The center temperature of the pressure roller measured by the thermistor does not reach 0°C for 8 seconds.
Causes: Defective thermopile. Defective thermistor. Loose connection.
Remedy:

Code: 572-02

Description: Pressure roller thermistor warm-up error: Center
The center temperature of the pressure roller measured by the thermistor does not reach 41°C within 8 seconds after the heater turns on.
Causes: Dirty thermopile lenses. Deformed thermistor.
Remedy:

Code: 573

Description: Pressure roller overheat : Center (software error)
The detected pressure roller temperature stays at 230°C or more for 1 second for 10 consecutive times.
Causes: The triac has shorted out. Defective IOB. Defective BCU.
Remedy:

Code: 574

Description: Pressure roller overheat : Center (hardware error)
The thermistor detects 240°C or more.
Causes: Defective PSU. Defective BCU. Defective IOB. Defective fusing control system.
Remedy: • Replace the PSU. • Replace the BCU. • Replace the IOB. • Replace the fusing unit and reset the counter of the fusing unit using SP3-902-014. Important: The fusing unit cannot be used because an abnormal high temperature was detected. • After this SC occurs, the counter reset of the fusing unit should be done manually using SP3-902-014 because the counter reset is not done automatically. • After replacing fusing unit, to set SP5-810-2 is necessary to reset this SC.

Code: 581

Description: NC sensor broken: Center
The sensor detects -17°C or less for 6 seconds
Causes: Defective thermopile. Defective thermistor. Loose connection.
Remedy:

Code: 591

Description: NC sensor broken: End
The sensor detects -17°C or less for 6 seconds.
Causes: Broken cables of thermopile. Broken cables of thermistor. Loose connection.
Remedy:

Code: 621

Description: Finisher/Mail box communication error
An error occurs during line connection. A communication error report is received from the UART.
Causes: The finisher's control board is faulty. Defective BCU/IOB. The finisher's connection is faulty. Reconnect the finisher/mail box cables.
Remedy: • Reconnect the finisher/mail box cables. • Replace the BCU. • Replace the finisher/mail box. • Turn the main power switch off and on.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie