Code :

Code: SC919
Description: External Controller Error 6
While EAC (External Application Converter), the conversion module, was operating normally, the receipt of a power line interrupt signal from the FLUTE serial driver was detected, or BREAK signal from the other station was detected.
Causes: • Power outage at the EFI controller
• EFI controller was rebooted
• Connection to EFI controller loose

Code: SC920
Description: Printer Error 1
An internal application error was detected and operation cannot continue.
Causes: • Software defective; switch off/on, or change the controller firmware if the problem is not solved
• Insufficient memory

Code: SC921
Description: Printer Error 2
When the printer application started, the font to use could not be found on the SD card
Causes: • The font is not on the SD card

Code: SC925
Description: NetFile Function Error
• The NetFile file management on the HDD cannot be used, or a NetFile management file is corrupted and operation cannot continue.
• The HDDs are defective and they cannot be debugged or partitioned, so the Scan Router functions (delivery of received faxes, document capture, etc.), Fabric services, and other network functions cannot be used.( HDD status codes displayed on the debug console are described below.)
Causes: • HDD defective
• Power supply to machine cut occurred while writing data to HDD
• Software error
• Please refer to the detailed descriptions below for recovery procedures.

Code: SC951
Description: F-Gate Signal Error
When the IPU has already received the F-GATE signal (laser writing start trigger signal), the IPU receives another F-GATE signal.
Causes: • Firmware defective
• Update the BCU firmware.
• BCU defective

‹ First < 20 21 22 23 24 25 >