Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B236 MP1350 B-C3 — Trang 5/25

Code: SC240

Description: LD Error
The LD error terminal of the LDB asserted an error.
Causes: • Cycle the machine off/on
• LDB harness connectors loose, broken, defective
• LDB defective
• IPU defective
• BCU defective

Code: SC300

Description: Charge Corona Error 1: Charge Leak
A abnormal detection signal (H) was detected for more than 60 ms. Also, during this time, the detected voltage remained below –4V for more than 50 ms.)
Causes: • Cycle the machine off/on
• CGB power pack harness connectors loose, broken, defective
• Corona wire caps loose, missing
• CGB power pack defective
• Charge corona unit connectors loose, broken, defective

Code: SC304

Description: Charge Corona Error 2: Grid Leak
A high feedback voltage (H) for the charge corona 60 ms. Also, during this time, the voltage of the charge grid remained less than –400V
Causes: • Cycle the machine off/on
• Charge unit set incorrectly (not locked in place)
• Charge unit connector loose, broken, defective

Code: SC305

Description: Charge Corona Wire Cleaner Error 1
One of these occurred after the charge corona cleaner motor was switched on: • The charge corona wire cleaner motor remained locked within 10 sec after the motor switched on. • The charge corona wire cleaner motor failed to lock within 45 s after the start of cleaning.
Causes: • Cycle the machine off/on
• Charge corona wire cleaner motor defective

Code: SC306

Description: Charge Corona Wire Cleaner Error 2
The cleaning pad of the charge corona wire cleaner mechanism failed to return to its home position.
Causes: Connectors between motor and IOB loose, broken, defective
• Charge wire dirty, defective, broken
• Wire cleaning pad defective
• Motor or motor board in motor unit defective

Code: SC312

Description: Pre-Charge Output Error 1: Leak
An abnormal signal (H) was detected continuously for 60 ms. During this time the pre-charge unit voltage remained less than –3 kV for more than 50 ms.
Causes: • Pre-charge unit set incorrectly.
• Pre-charge unit contact is broken or defective.

Code: SC313

Description: Pre-Charge Output Error 1: Grid Output
An abnormal signal (H) was detected continuously for 60 ms. During this time the pre-charge grid voltage remained less than –400V for more than 50 ms.
Causes: • Pre-charge unit set incorrectly
• Pre-charge unit contact is broken or defective

Code: SC320

Description: Development Bias Error
An abnormal detection signal (H) was detected continuously for 60 ms. During this time the voltage exceeded –90µA for more than 50 ms
Causes: • Development power pack connectors loose, broken, defective
• Development unit connectors loose, broken, defective
• Development power pack defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie