Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D043 ML325D — Trang 2/10

Code: 193

Description: Image transfer error
Scanned images are not transferred to the controller memory within 1 minute.
Causes: • BICU board defective • Controller board defective

Code: 198

Description: Memory address error
The BICU board does not receive memory addresses from the controller board.
Causes: • The firmware programs of the engine and the controller do not match. • BICU board defective • Controller board defective

Code: 202

Description: Polygon Motor Error 1: ON Timeout
The machine does not detect the polygon motor lock signal for 10 seconds after the polygon motor has turned on.
Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

Code: 203

Description: Polygon Motor Error 2: OFF Timeout
The machine does not detect the polygon motor unlock signal for 3 seconds after the polygon motor has turned off.
Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

Code: 204

Description: Polygon Motor Error 3: XSCRDY Signal Error
The machine does detect the polygon motor unlock signal for 0.2 seconds after the polygon motor has turned on.
Causes: • Polygon motor defective • SCRATCH error • I/F harness disconnected or loose

Code: 220

Description: Laser synchronization error
The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
Causes: • Poor connection between the LD unit and the BICU board • Damaged cable between BICU and LD unit • LD unit out of position • LD unit defective • BICU board defective

Code: 230

Description: No laser writing signal (F-GATE) error
The laser-writing signal (F-GATE) fails to turn Low after the laser crosses 5 mm on the drum surface from the laser writing start position.
Causes: • BICU board defective • The fax controller or printer controller has a poor connection • Fax controller or printer controller defective

Code: 302

Description: Charge roller current leak
A current leak signal for the charge roller is detected.
Causes: • Charge roller damaged • High voltage supply board defective • Poor connection of the PCU
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie