Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D118 MPC305SP GR-C1 — Trang 12/21

Code: 562-03

Description: Heating roller warm-up error (sensor 3)
The center temperature of the heating roller does not reach the target reload permit pressure within the prescribed time.
Causes: Dirty thermopile lenses. Defective heating roller thermistor. Input voltage out of the warranty (out of specification).
Remedy: 1. Check and clean the thermopile lenses. 2. Replace the thermopile 3. Replace the thermistor.

Code: 563

Description: Pressure roller overheat (software error): Center
The temperature detected by the pressure roller thermistor stays at the prescribed temperature within the prescribed time.
Causes: Defective PSU. Defective BICU
Remedy: 1. Replace the PSU. 2. Replace the BICU.

Code: 564

Description: Pressure roller overheat (hardware error): Center
The temperature detected by the pressure roller thermistor detects prescribed temperature.
Causes: Defective BICU. Defective fusing control system.
Remedy: 1. Replace the thermistor. 2. Replace the BICU.

Code: 571

Description: Pressure roller thermistor error: End
The temperature detected by the pressure roller thermistor does not reach 0 °C within the prescribed time.
Causes: Loose connection of the pressure roller thermistor. Defective thermopile. Defective pressure roller thermistor.
Remedy: 1. Check if the pressure roller thermistor is firmly connected. 2. Replace the thermopile. 3. Replace the pressure roller thermistor.

Code: 572-03

Description: Heating roller warm-up error (sensor 4)
The temperature of the heating roller does not reach 20 °C within the prescribed time.
Causes: Dirty thermopile lenses. Defective heating roller thermistor. Input voltage out of the warranty (out of specification).
Remedy: 1. Check and clean the thermopile lenses. 2. Replace the thermopile 3. Replace the thermistor.

Code: 573

Description: Pressure roller overheat (software error): End
The temperature detected by the pressure roller thermistor stays at the prescribed temperature within the prescribed time.
Causes: Defective PSU. Defective BICU
Remedy: 1. Replace the PSU. 2. Replace the BICU.

Code: 574

Description: Pressure roller overheat (hardware error): End
The temperature detected by the pressure roller thermistor detects prescribed temperature.
Causes: Defective BICU. Defective fusing control system
Remedy: 1. Replace the thermistor. 2. Replace the BICU.

Code: 610

Description: Mechanical counter error: Bk
This SC is only for NA models. The machine detects the mechanical counter error when SP5987-001 is set to "1".
Causes: Disconnected mechanical counter. Defective mechanical counter.
Remedy: 1. Check or replace the mechanical counter.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie