Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D131 MP6002 — Trang 21/33

Code: 722-72

Description: Front shift jogger motor error (D610) The sides fences do not retract within the prescribed time after the shift jogger motor switches on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Shift jogger motor disconnected, defective • Shift jogger motor overloaded due to obstruction • Shift jogger HP sensor disconnected, defective

Code: 722-74

Description: Shift jogger retraction motor error (D610) The side fences do not retract within the prescribed time after the retraction motor switches on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Motor harness disconnected, loose, defective • Motor defective • Motor overload • HP defective

Code: 722-75

Description: Return roller motor error (D610) Occurs during the operation of the lower tray pressure motor.
Causes: • Motor harness disconnected, loose, defective • Motor overloaded • Home position sensor harness disconnected, loose, defective • Home position defective

Code: 722-80

Description: Finisher staple trimming hopper full (D610) The staple waste hopper is full of cut staples.
Causes: • If the hopper is full, empty the hopper • If the hopper is not full, the hopper full sensor is disconnected, defective

Code: 722-81

Description: Finisher transport motor error (D610) The encoder pulse of the finisher transport motor does not change state (high/low) within 600 ms and does not change after 2 retries.
Causes: • Finisher transport motor defective • Transport motor harness disconnected, or defective • Finisher main board defective

Code: 722-83

Description: Finisher punch motor error (D610) The punch HP sensor is not activated within the specified time after the punch motor turned on. The 1st detection failure issues a jam error, and the 2nd failure issues this SC code.
Causes: • Punch HP sensor disconnected, defective • Punch motor disconnected, defective • Punch motor overload due to obstruction

Code: 724-71

Description: Shift Motor Error The shift tray half-turn sensors: Failed twice to detect the shift tray at the home position at the specified time. -or- Failed twice to detect that the shift tray had left the home position.
Causes: If the motor is operating • Half-turn sensor 1, 2 harnesses loose, broken, defective • One of the half-turn sensors is defective If the motor is not operating: • Motor blocked by an obstruction • Motor harness loose, broken, defective • Motor defective • Finisher main board defective

Code: 725-01

Description: Downstream finisher communication error (D615) No response signal was received from the downstream finisher (D615) after 3 attempts
Causes: • Finisher I/F cable loose, broken defective • Finisher control board defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie