Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D131 MP6002 — Trang 9/33

Code: 530-00

Description: Main fan error The main fan motor lock signal goes high for 5 s while the fan is on.
Causes: • Fan motor overloaded due to obstruction • Fan connector disconnected

Code: 540-01

Description: Fusing exit motor error The PLL lock signal was low for 2 s during motor operation.
Causes: • Motor lock caused by physical overload • Motor drive PCB defective

Code: 540-02

Description: Fusing web motor error 1 The amount of current detected during operation of the web motor exceeded 350 mA in 5 successive samples.
Causes: • Motor connection loose, broken, defective • Motor disconnected • Motor lock or short

Code: 540-03

Description: Fusing web motor error 2 SC540-02 has occurred three times and the machine has shut down automatically due to failure of the web motor.
Causes: • Web motor harness loose, broken, defective • Web motor disconnected • Web motor defective

Code: 540-04

Description: Fusing web motor error 3 SC540-02 has occurred at total of 10 times and the machine has shut down automatically due to failure of the web motor.
Causes: • Web motor harness loose, broken, defective • Web motor disconnected • Web motor defective

Code: 541

Description: Fusing thermistor open The fusing temperature detected by the center thermistor was below 0°C for 7 s.
Causes: • Thermistor open • Thermistor connector defective • Thermistor damaged, or out of position • Fusing temperature –15% less than the standard input voltage

Code: 542-001

Description: Fusing temperature warm-up error 1: Center themistor The center thermistor that touches the hot roller determined that the hot roller failed to reach the warm-up temperature within the prescribed time.
Causes: • Fusing lamp disconnected • Thermistor warped, out of position • Thermostat has opened

Code: 542-002

Description: Fusing temperature warm-up error 2: Center themistor The center thermistor that touches the hot roller determined that the hot roller failed to reach 100 within the prescribed time.
Causes: • Fusing lamp disconnected • Thermistor warped, out of position • Thermostat has opened
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie