Description: Fusing reload temperature error 1: End thermistor The end thermistor (contact type) could not detect: • 100°C 25 seconds after the start of the warm-up cycle. • A change in temperature more than 16 degrees for 5 seconds. • The reload temperature with 56 seconds after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected • Thermistor connector loose, broken, defective • Thermistor out of position, installed incorrectly • Thermostat open
Description: Fusing reload temperature error 3: End thermistor The hot roller did not reach the prescribed temperature within 3 sec, after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected • Thermistor connector loose, broken, defective • Thermistor out of position, installed incorrectly • Thermostat open
Description: Fusing thermistor error 4: End thermistor (software) The end thermistor (contact type) was at 240°C (464°F) for more than 1 second. The temperature is read 10 times every second. (at 0.1 s intervals).
Causes: • PSU defective • IOB control board defective • BICU control board defective
Description: Fusing jam: 3 counts At the fusing exit sensor the paper was detected late for three pulse counts (lag error), and SP1159 was on.
Causes: • If this SC occurs, the machine cannot be used until the service technician cancels the SC code. • This SC occurs only if SP1159 has been set to "1" (On). (Default: 0 (Off)).
Description: Fusing pressure release motor error During copying, the HP sensor could not detect the actuator, tried again 3 times and could not detect.
Causes: • Motor lock because of too much load • Motor driver defective • HP sensor defective, disconnected, connector defective, harness damaged
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.