Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D133 MP9002 — Trang 11/33

Code: 552-01

Description: Fusing reload temperature error 1: End thermistor The end thermistor (contact type) could not detect: • 100°C 25 seconds after the start of the warm-up cycle. • A change in temperature more than 16 degrees for 5 seconds. • The reload temperature with 56 seconds after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected • Thermistor connector loose, broken, defective • Thermistor out of position, installed incorrectly • Thermostat open

Code: 552-02

Description: Fusing reload temperature error 2: End thermistor The hot roller did not reach 100C within the prescribed time.
Causes: • Fusing lamp disconnected • Thermistor connector loose, broken, defective • Thermistor out of position, installed incorrectly • Thermostat open

Code: 552-03

Description: Fusing reload temperature error 3: End thermistor The hot roller did not reach the prescribed temperature within 3 sec, after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected • Thermistor connector loose, broken, defective • Thermistor out of position, installed incorrectly • Thermostat open

Code: 553

Description: Fusing thermistor error 4: End thermistor (software) The end thermistor (contact type) was at 240°C (464°F) for more than 1 second. The temperature is read 10 times every second. (at 0.1 s intervals).
Causes: • PSU defective • IOB control board defective • BICU control board defective

Code: 555

Description: Fusing lamp error After the start of the warmup cycle, a fusing lamp was at full power for 1.8 s but the hot roller did not turn.
Causes: • Thermistor bent, out of position • Fusing lamp disconnected • Circuit breaker opened

Code: 557

Description: Zero cross signal error High frequency noise was detected on the powe r line.
Causes: • No action required. The SC code is logged and the operation of the machine is not affected.

Code: 559

Description: Fusing jam: 3 counts At the fusing exit sensor the paper was detected late for three pulse counts (lag error), and SP1159 was on.
Causes: • If this SC occurs, the machine cannot be used until the service technician cancels the SC code. • This SC occurs only if SP1159 has been set to "1" (On). (Default: 0 (Off)).

Code: 569

Description: Fusing pressure release motor error During copying, the HP sensor could not detect the actuator, tried again 3 times and could not detect.
Causes: • Motor lock because of too much load • Motor driver defective • HP sensor defective, disconnected, connector defective, harness damaged
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie