Causes: Energy save I/O subsystem detected some abnormality. • Energy save I/O subsystem defective • Energy save I/O subsystem detected a controller board error (non-response). • Error was detected during preparation for transition to STR.
Remedy: • Turn the main power off/on. • Replace the controller board.
Causes: Energy save I/O subsystem detected some abnormality. • Energy save I/O subsystem defective • Energy save I/O subsystem detected a controller board error (non-response). • Error was detected during preparation for transition to STR.
Remedy: • Turn the main power off/on. • Replace the controller board.
Causes: Energy save I/O subsystem detected some abnormality. • Energy save I/O subsystem defective • Energy save I/O subsystem detected a controller board error (non-response). • Error was detected during preparation for transition to STR.
Remedy: • Turn the main power off/on. • Replace the controller board.
Description: EEPROM read data error Compared the data from 3 areas of the EEPROM mirror data with the original data and all 3 of them were different from the original data.
Causes: Data in the specific area of the EEPROM has been modified.
Description: Nand-Flash updating verification error During remote ROM update or ROM update, the SCS detected a write error (verify error) regarding the data written to the Nand-Flash.
Description: Nand-Flash bad block number exceeding the threshold When the status of the Nand-Flash was checked at power-on or when returning from energy saver mode, the number of bad blocks exceeded the threshold.
Causes: Nand-Flash bad block number exceeding the threshold
Description: Number of times of Nand-Flash block erase exceeding the threshold When the status of the Nand-Flash was checked at power-on or when returning from energy saver mode, the number of times the block was erased exceeded the threshold.
Causes: Number of times of Nand-Flash block erase exceeding the threshold