Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh M021 SP5210DN — Trang 5/10

Code: 670

Description: Engine startup error
The engine board fails to respond within 70 seconds when the machine is turned on.
Causes: Connections between the engine board and the controller board are loose, disconnected, or damaged
Remedy: 1. Connect the harnesses properly or replace the new one. 2. Replace the engine board. 3. Replace the controller board.

Code: 671

Description: Illegal engine board detection error
The machine code sent from the engine board is incorrect when the machine is turn on.
Causes: Installing another machine's engine board. Defective engine board. Incorrect NVRAM on the engine board
Remedy: 1. Install the proper NVRAM. 2. Replace the engine board with proper one.

Code: 681

Description: RFID communication error
Machine cannot communicate with the RFID. Retrying 3 times after the error detection when communicating with a RF tag cannot recover from the error.
Causes: Defective Reader/Writer. Disconnect harnesses. External noise. Defective RFID tag or no ID tag. Defective RFID unit.
Remedy: • Replace the RFID unit. • Replace the AIO unit. • Turn the Power Switch Off and On.

Code: 683

Description: RFID unit check error
When the unit checking is performed, a transmission error is detected more than 3 times.
Causes: External noise
Remedy: • Reset the AIO unit. • Open and close the front cover.

Code: 688

Description: CTL_PRREQ_N signal does not come.
The PRREQ signal is not received for 130 seconds after paper reaches the registration waiting point.
Causes: External noise. Defective engine board
Remedy: • Turn the Power Switch Off and On. • Replace the engine board.

Code: 690

Description: GAVD communication error
The machine detects an error in the data of the ASIC.
Causes: Defective GAVD. Defective CPU. Defective BCU.
Remedy: • Turn the Power Switch Off and On. • Replace the engine board.

Code: 790

Description: Bank over stacking error
More than 4 PTUs installed.
Causes: Excess bank stack
Remedy: Decrease the number of PTUs to within 4.

Code: 819

Description: Fatal kernel error
Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: System program defective. HDD defective. Controller board defective. Optional board defective.
Remedy: 1. Replace the controller firmware. 2. Replace the Controller board. 3. Replace the optional board or HDD.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie