Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh M052 SP5200S — Trang 5/14

Code: 544

Description: Fusing overheat error 2 (center) A fusing temperature over 250°C is detected at the center of the hot roller by the fusing temperature monitor circuit in the BCU board.
Causes: • TRIAC short on PSU (PSU defective) • BICU board defective • Power supply voltage unstable
Remedy:

Code: 545

Description: Heating roller fusing lamp consecutive full power 1 When the fusing unit is not running in the ready condition, the heating roller fusing lamp keeps on full power for 12 seconds.
Causes: • Broken heating roller thermostat • Broken heating roller fusing lamp
Remedy:

Code: 547

Description: Zero cross signal detection error Zero cross signals were not detected within the prescribed time.
Causes: • PSU, BICU harness loose or broken • PSU defective
Remedy:

Code: 557

Description: Zero cross waveform signal error The waveform of the zero cross signal was detected out of range.
Causes: • Electrical noise on the power supply line
Remedy:

Code: 559

Description: Consecutive fusing unit paper jams Three consecutive paper jams occurred in the fusing unit. The paper jam counter for the fusing unit reaches 3 times. The paper jam counter clears after the paper feeds correctly. Note: This SC is issued only if SP1159 is set to "1".
Causes: • Remove the paper jam in the fusing unit. • Make sure that the paper path in the fusing unit is clear.
Remedy:

Code: 610

Description: Mechanical counter error: K - - This SC is only for NA models. The machine detects the mechanical counter error when SP5987-001 is set to "1".
Causes: • Disconnected mechanical counter • Defective mechanical counter • Defective BICU
Remedy:

Code: 620

Description: Communication error between BICU and ADF A break occurred in the connection between the BICU and ADF
Causes: • ADF disconnected • ADF defective • BICU harness connection loose, broken • BICU defective • External noise
Remedy:

Code: 621

Description: Communication timeout between BICU and finisher A break (LOW) signal was received from the finisher.
Causes: • Finisher serial cable connection loose, broken • BICU defective • Finisher main board defective • External noise
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie