Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh M052 SP5200S — Trang 13/14

Code: 900

Description: Electrical total counter error. The total count contains something that is not a number.
Causes: • NVRAM incorrect type • NVRAM defective • NVRAM data scrambled • Unexpected error from external source
Remedy:

Code: 920

Description: Printer Error 1 An internal application error was detected and operation cannot continue.
Causes: • Software defective • Insufficient memory
Remedy:

Code: 921

Description: Printer error 2 When the application started, the necessary font was not on the SD card.
Causes: • Font not on the SD card
Remedy:

Code: 990

Description: Software performance error
Causes: The software attempted to perform an unexpected operation due to: 1) software bug, 2) incorrect internal parameter, 3) insufficient working memory.
Remedy: • Turn the machine power off/on • Reinstall the controller and/or main firmware Note: When this SC occurs, the file name, address, and data will be stored in NVRAM. This information can be checked by using SP7-403. Note the above data and the situation in which this SC occurs. Then report the data and conditions to your technical control center.

Code: 991

Description: Software continuity error
Causes: The software attempted to perform an unexpected operation. However, unlike SC990, the object of the error is continuity of the software.
Remedy: • No operation required. Note: This SC code does not appear on the panel, and is only logged.

Code: 992

Description: Unexpected Software Error Software encountered an unexpected operation not defined under any SC code.
Causes: • Software defective • An error undetectable by any other SC code occurred
Remedy:

Code: 995

Description: CPM setting error
Causes: -001 • Defective BICU Input the serial number with SP5811-004, and turn the main power switch off/on. -002 • Defective NVRAM on the controller • Defective controller 1. Install a new NVRAM, and turn off and on the main power switch after SC995-002 has occurred. 2. Reinstall the previous NVRAM or download the information with SP5825-001, after that turn the main power off and on. -003 • Incorrect type controller installed • Defective controller Replace the controller board with the correct type. -004 • Incorrect model controller installed. Replace the controller with the correct model.
Remedy:

Code: 997

Description: Application function selection error
Causes: Application selected by the operator did not start or end normally due to a software problem. An option required by the application may not be installed.
Remedy: • Confirm which devices are required for the application. • Make sure all devices are configured correctly. • If the problem is with the fax unit, the nesting of the fax group may be too complicated
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie