Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Riso FR3910 — Trang 2/4

Code: T17

Description: Replace Battery
• When the battery voltage is less than 2.4 V at power-on, all reset, or end of operation.

Code: T18

Description: Sorter Error
• If an error signal is received from the sorter.

Code: T19

Description: Thermal Pressure Motor Lock
• If the TPH Pressure switch has not been depressed within 4 seconds after the TPH Pressure motor was activated to lower the TPH.
• If the TPH Pressure switch has not been released within 4 seconds after the TPH Pressure motor was activated to raise the TPH.

Code: T2

Description: Elevator Motor Lock
• In 15 seconds from turning ON of the Elevator motor in upward direction, the Elevator upper limit sensor is not pushed.
• In 15 seconds from turning ON of the Elevator motor in downward direction, the light path of the Elevator lower limit sensor is not blocked.
• In 3 seconds from turning ON of the Elevator motor in upward direction, the Elevator lower sensor is held blocked.
• In 3 seconds from turning ON of the Elevator motor in downward direction, the Elevator upper limit sensor is held pressed down.

Code: T20

Description: Wing Motor Lock
• If neither of the Jump wing sw1 or sw2 has been depressed within 5 seconds after the Wing motor was activated.
• If neither of the Jump wing sw1 or sw2 has been released within 5 seconds after the Wing motor was activated.

Code: T3

Description: Clamp Error (1)
• In 4 seconds from turning ON of the Clamp solenoid in clamp retrial, the Clamp safety switch is held still pressed down.
• In 4 seconds from turning OFF of the Clamp solenoid, the Clamp safety SW has not been pressed.
• In 8 seconds from turning ON of the Clamp motor in opening direction in clamp retrial, the 180° Angular sensor has not detected magnet.
• In 8 seconds from turning ON of the Clamp motor in closing direction in clamp retrial, the 0° Angular sensor has not detected magnet.
In any of the above cases, master making is performed to the end.

Code: T30

Description: P. -F. Tray Slide Pulse Motor
• When the Paper feed tray position sensor is not turned on/ off within 165 pulses(approx. 3 second) after the P. -F. tray slide pulse motor is turned on.

Code: T4

Description: Overflow
• When ink is in contact with the Overflow sensor. The Drum set switch need be pushed.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie