Code :

Code: 01-000
Display: Door Open/Check Transfer Belt
Description: The front cover or the top cover is not securely latched or the transfer belt is not installed.
Causes: 1. Harness is defective, Connector is not connected properly. 2. Sensor is defective.

Code: 01-004
Display: Paper Jam in MP tray
Description: At printing, the paper from the MP tray has not reached to the feed sensor within a programmed period of time after pick up.
Causes: 1. Pickup Clutch does not work. 2. Pickup roller rubber is worn out. 3. Feed Sensor is defective.

Code: 01-005
Display: Paper jam in tray 1
Description: At printing, the paper from the tray1 has not reached to a feed sensor within a programmed period of time after pick up.
Causes: 1. Pickup Clutch does not work. 2. Pickup roller rubber is worn out. 3. Feed Sensor is defective.

Code: 01-006, 01-018
Display: Paper jam in tray 2
Description: At printing, the paper from the tray2 has not reached to a feed sensor within a programmed period of time after pick up.
Causes: 1. Pickup Clutch does not work. 2. Pickup roller rubber is worn out. 3. Feed Sensor is defective.

Code: 01-009
Display: Paper jam inside of machine
Description: Paper jam inside of machine 1. At Warm-up, the paper is jamming at Regi sensor or Feed sensor. 2. At printing, the paper is detecting at Regi sensor or Feed sensor continually. 3. At printing, the paper is not detected at exit sensor within a regular time.
Causes: 1. Feed sensor or Regi Sensor is defective. 2. Exit sensor is defective. 3. Feed Clutch is defective. 4. Regi Clutch is defective.

Code: 01-010
Display: Paper jam in exit area
Description: Paper jam in exit area
Causes: - If there is no jammed paper but error has occurred at warm-up, exit sensor is defective.

Code: 01-014
Display: Paper jam at the bottom of duplex path
Description: 1. At Warm-up, Duplex Ready sensor has detected the paper. 2. At Printing, Duplex sensor is not off within a programmed period of time after paper moves into duplex path.
Causes: 1. Check the Duplex Ready Sensor Harness and Connector. 2. Check if the UI message is changed by the Duplex Ready Sensor operation. 3. Check the duplex ready sensor

Code: 01-017
Display: Output bin Full. Remove paper
Description: The out-bin full sensor is on for 600ms.
Causes: 1. Check the Out-Bin Full Sensor Harness and Connector. 2. Check if the UI message is changed by the Out-Bin Full Sensor operation. 3. Check the Out-Bin Full Sensor.

1 2 3 4 >