Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp ARP350 — Trang 6/9

Code: F2 05

Description: CRUM error. Communication with IC chip cannot be made.
Causes: IC chip trouble Improper cartridge
Remedy: Insert a proper cartridge.

Code: F2 39

Description: Process thermistor open
Causes: Process thermistor trouble Process thermistor harness disconnection PCU PWB trouble
Remedy: Check connection of harness and connector of the process thermistor. Check PCU PWB.

Code: F3 12

Description: Machine no. 1 tray lift-up trouble. PED does not turn ON in the specified time. LUD does not turn ON in the specified time.
Causes: PED/LUD trouble No. 1 tray lift-up trouble Check connection of harness between the PCVU PWB, lift-up unit, and paper feed unit.
Remedy: Check PED, LUD, and their harness and connectors. Check the lift-up unit.

Code: F3 22

Description: Multi purpose tray lift-up trouble. MCPED does not turn ON in the specified time. MCLUD does not turn ON in the specified time.
Causes: MCPED/MCLUD trouble Multi purpose tray lift-up motor trouble Harness disconnection f the PCU PWB, the lift-up unit, and the paper feed unit.
Remedy: Check MCPED, PCLUD, and their harness and connectors. Check the lift-up unit.

Code: F9 02

Description: PRT Centro port check error. Controller Centro port trouble
Causes: Centro port trouble Controller PWB trouble
Remedy: Replace the Controller PWB.

Code: F9 03

Description: NIC port check error
Causes: NIC port trouble NIC PWB trouble Controller PWB trouble
Remedy: Replace the NIC PWB. Replace the Controller PWB.

Code: H2 00, H2 HL1

Description: thermistor open Fusing unit not installed. Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
Causes: Thermistor trouble Control PWB trouble Fusing section connector disconnection AC power trouble Fusing unit not installed
Remedy: Check harnesses and connectors from the thermistor to the control PWB. Use DIAG (SIM14) to clear the self diag display.

Code: H2 01, H2 HL2

Description: thermistor open Fusing unit not installed. Thermistor is open. (An input voltage of 2.92V or above is detected.) Fusing unit not installed
Causes: Thermistor trouble Control PWB trouble Fusing section connector disconnection AC power trouble Fusing unit not installed
Remedy: Check harnesses and connectors from the thermistor to the control PWB. Use DIAG (SIM14) to clear the self diag display.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie