Code :

Code: 917
Description: 917.00 Transfer service error 917.01 Transfer servo result too low.

Code: 920
Description: 920.00 Under temperature during steady state control. 920.01 Fuser took too long to heat up after transitioning to new enhanced mode. 920.02 Fuser fell too far below desired temperature while printing. 920.03 Fuser too cool while checking for slope change. 920.04 Fuser too cool when heating to desired temperature after slope change. 920.05 Fuser under temperature while printing 920.06 Fuser under temperature while printing 920.07 Fuser under temperature while printing 920.08 Fuser temperature did not increase after IR recovery. 920.20 Belt fuser under temperature during steady state control. This can occur in printing or standby modes.

Code: 921
Description: 921.00 Under temperature during standby control. 921.01 Fuser temperature did not reach standby temperature after two attempts

Code: 922
Description: 922.00 Fuser failed to ramp to target temperature 922.01 Fuser did not reach standby temperature in time (standby control) 922.07 Media reached fuser nip and fuser is under temperature 922.08 Fuser warm-up failure (motor start condition) 922.09 Fuser warm-up failure (compression set) 922.20 Belt fuser failed to reach the preheat temperature for the motor to start during warm-up. 922.21 Belt fuser was under temperature when the media reached the fuser nip.

Code: 923
Description: 923.00 Fuser is over temperature. 923.01 Fuser is over temperature. This applies to the fuser and belt fusers.

Code: 924
Description: 924.00 Open thermistor check. 924.01 Open thermistor check failure. This applies to the fuser and belt fusers. 924.02 Open thermistor check failure. The ADC failed to converge. Possible noisy thermistor signal. This applies to the fuser and belt fusers.

Code: 927
Description: 927.00 Service fan error 927.03 Main fan took too long to ramp up 927.04 Main fan is under speed or stalled during speed adjustment state 927.05 Main fan overspeed during speed adjustment state. 927.06 Main fan capture data is invalid and speed control is at maximum in fan control idle state 927.07 Main fan capture data is invalid and speed control is at maximum in fan control adjustment state.

1 2 >