• Code: 922.17
• Description: Fuser has taken too long to reach desired temperature after increasing interpage gap. Fuser page count between 100,000 and 199,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.22
• Description: Hot roll took too long to reach the beginning lamp detection temperature. Fuser page count between 200,000 and 299,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.23
• Description: Hot roll reached final lamp detection temperature but took longer than largest time in lookup table. Fuser page count between 200,000 and 299,999.
• Causes: Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.24
• Description: Hot roll timed out in trying to reach the final lamp detection temperature. Fuser page count between 200,000 and 299,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.25
• Description: After hot roll lamp detection, did not roll over to steady state control in time. Fuser page count between 200,000 and 299,999.
• Causes: The control code has been lost.
• Remedy: See 922.02

• Code: 922.26
• Description: Hot roll did not reach operating temperature in time (new enhanced control). Fuser page count between 200,000 and 299,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.27
• Description: Fuser has taken too long to reach desired temperature after increasing interpage gap. Fuser page count between 200,000 and 299,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02

• Code: 922.32
• Description: Hot roll took too long to reach the beginning lamp detection temperature. Fuser page count between 300,000 and 399,999.
• Causes: • Low wattage or incorrect lamp. • Bad thermistor, circuit, or cabling. • Fuser not receiving sufficient AC power. • Poor supply line voltage.
• Remedy: See 922.02