Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Toshiba e-Studio 6570C — Trang 12/44

Code: CB40

Description: Rear aligning plate motor abnormality: Rear aligning plate motor is not rotating or aligning plate is not moving normally. [MJ-1103/1104] Front alignment motor abnormality: The front alignment motor is not rotating or the front alignment plate is not moving normally. [MJ1103/1104]
Causes: Front alignment motor Finisher control board
Remedy: Alignment plate • Is there any mechanical problem when the front alignment plate is moved? Front alignment motor (M9) • Connector check • Harness check Finisher control board • Connector check (CN10) • Board check

Code: CB50

Description: Stapler home position error: The stapler home position sensor does not work. [MJ-1103/1104]
Causes: Stapler Finisher control board
Remedy: Stapler • Connector check • Harness check Finisher control board • Connector check (CN2) • Board check

Code: CB51

Description: Stapler shift home position error: The stapler is not at the home position. [MJ-1103/1104]
Causes: Stapler Stapler unit home position sensor Stapler unit shift motor Finisher control board
Remedy: Stapler • Is there any mechanical problem when the stapler is moved? • Connector check • Harness check Stapler unit home position sensor (S10) • Sensor check • Connector check • Harness check Stapler unit shift motor (M4) • Motor check • Connector check • Harness check Finisher control board • Connector check (CN1, CN5) • Board check

Code: CB60

Description: Stapler shift motor abnormality: Stapler shift motor is not rotating or staple unit is not moving normally. [MJ-1103/1104]
Causes: Stapler Stapler unit shift motor Finisher control board
Remedy: Stapler • Is there any mechanical problem when the stapler is moved? • Connector check • Harness check Stapler unit shift motor (M4) • Motor check • Connector check • Harness check Finisher control board • Connector check (CN1, CN5) • Board check

Code: CB80

Description: Backup RAM data abnormality: Abnormality of checksum value on finisher controller PC board is detected when the power is turned ON
Causes: Finisher control board
Remedy: Equipment • Is the error recovered when the power of the equipment is turned OFF and then back ON? Finisher control board • Connector check • Board check

Code: CB81

Description: Flash ROM abnormality: Abnormality of checksum value on finisher controller PC board is detected when the power is turned ON. [MJ-1103/1104]
Causes: Finisher control board
Remedy: Equipment • Is the error recovered when the power of the equipment is turned OFF and then back ON? Finisher control board • Connector check • Board check

Code: CB82

Description: Finisher - Main CPU program error
Causes: Finisher control board
Remedy: Finisher control board • Update the firmware version of the finisher control PC board (FIN). • Connector check • Board check

Code: CB83

Description: Saddle Stitch Finisher - Main CPU program error
Causes: Saddle control PC board
Remedy: Saddle control PC board • Update the firmware version of the saddle control PC board (SDL). • Connector check • Board check
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie