Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Xerox WorkCentre 3325 — Trang 2/6

Code: 04-500

Display: Motor Error Turn off then on
Description: Main motor not running. Replace the Main Drive Motor. If fault persists, replace the Main Board.
Causes: • Main Drive Motor • Main Board Phaser 3320 WorkCentre 3315/3325

Code: 05-100

Display: Original Paper Jam Paper jam inside of Doc Feeder.
Description: The lead edge of The document failed to actuate the Scan Sensor within the correct time after actuating the Registration Sensor. The Scan Sensor does not turn off within the correct time after the Registration Sensor is off. Open ADF/DADF Cover and remove jammed media.
Causes: • DADF Pick Up Unit • ADF Pick Up Assembly • ADF Paper Path Assembly • DADF Feed Roller • DADF Rubber Unit • DADF Lifting Solenoid. • DADF Feed Sensor • DADF Registration Sensor • DADF Drive • ADF Drive • DADF Assembly • ADF Assembly

Code: 05-600

Display: Original Paper Jam Paper jam inside of Doc Feeder.
Description: Occurs when one or more sensors are on when power is on. Paper in the DADF paper path when at power up. Open ADF/DADF Cover and remove jammed media.
Causes: • DADF Pick Up Unit • ADF Pick Up Assembly • ADF Paper Path Assembly • DADF Feed Roller • DADF Rubber Unit • DADF Lifting Solenoid. • DADF Feed Sensor • DADF Registration Sensor • DADF Drive • ADF Drive • DADF Assembly • ADF Assembly

Code: 05-900

Display: Original Paper Jam Paper jam inside of Doc Feeder.
Description: A jam occurred near the top of the Duplex Assembly. Open the Rear Door and remove the jammed paper. Remove the Duplex Unit and check for jammed paper.
Causes: • Duplex Assembly

Code: 05-920

Display: Scanner door Open
Description: DADF Top Cover open. Close the DADF Top Cover.
Causes:

Code: 06-100

Display: LSU Motor Error
Description: The LSU could not reach the READY state within the defined time. Turn the printer on and then off and then check to see if the error persists.
Causes: • Laser Unit • Main Board (Phaser 3320) (WorkCentre 3315/3325)

Code: 06-200

Display: LSU Hsync Error
Description: The laser beam was not detected within the set time. Turn the printer on and then off and then check to see if the error persists.
Causes: • Laser Unit • Main Board (Phaser 3320) (WorkCentre 3315/3325)

Code: 07-110

Display: Tray 1 Empty
Description: No paper in Tray 1 Load paper in Tray 1.
Causes: • Paper Empty Sensor • Main Board (Phaser 3320) (WorkCentre 3315/3325)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie