Mã lỗi Zebra 90XiIII plus — Trang 3/4
Code:
Tất cả lỗi (26)
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
Code:
17
Display:
Description: Fine gray lines on blank labels at angles.
Causes: Wrinkled ribbon.
Code:
18
Display:
Description: Wrinkled ribbon
Causes: Ribbon fed through machine incorrectly. Ribbon supply spindle tension needs adjusting. Incorrect burn temperature. Incorrect printhead pressure or balance. Media not feeding properly; walking from side to side. Strip plate needs adjusting. Printhead needs realigning with platen roller. Ribbon take-up spindle tension needs adjusting. Three-point mount for ribbon supply spindle needs adjusting. Ribbon supply core slipping; spindle blades need adjusting.
Code:
19
Display:
Description: Light printing or no printing on left or right side of label.
Causes: Printhead needs balancing.
Code:
20
Display:
Description: Misregistration or skipped labels.
Causes: Improper sensor type selected. Misadjusted media sensors. Improper spindle tensions. Improper ZPL format.
Code:
21
Display:
Description: Misregistration and misprint of one to three labels. Vertical drift in top-of-form registration.
Causes: Media was pulled when motor was not moving. Printer in Rewind or Peel-Off Mode turned on without media or liner around rewind spindle. Misadjusted media sensor. Tolerances of the mechanical parts and printer modes create ±1 mm vertical drift
Code:
22
Display:
Description: Label jam in rear area of printhead.
Causes: Upper media plate (snap plate) needs cleaning.
Code:
23
Display:
Description: Printed label feeds out and then backfeeds, immediately resting under the printhead.
Causes: Printer set for Cutter Mode with no cutter installed.
Code:
24
Display:
Description: Changes in parameter settings did not take effect.
Causes: Parameters set incorrectly. If problem persists, there may be a problem on the main logic board.