Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Brother DCP9270CDN — Trang 25/28

Code: E0

Description: Program error. (An error occurred in the ROM checksum.)
Causes: 1 Firmware update failure. 2 Main PCB failure
Remedy: 1 Firmware update failure Write the latest firmware. 2 Main PCB failure Replace the main PCB ASSY.

Code: E1

Description: Program error.
Causes: 1 Firmware update failure. 2 Main PCB failure
Remedy: 1 Firmware update failure Upload the latest firmware. 2 Main PCB failure Replace the main PCB ASSY.

Code: E2

Description: When the center thermistor is lower than the idle temperature, it is detected that the side thermistor temperature is higher than 280 °C.
Causes: 1 Heat roller dirty. 2 Harness connection failure between paper eject sensor PCB ASSY and fuser unit. 3 Side thermistor or center thermistor failure. 4 Paper eject sensor PCB failure. 5 Main PCB failure
Remedy: 1 Heat roller dirty Clean the heat roller. 2 Harness connection failure between paper eject sensor PCB ASSY and fuser unit Check the harness connection between the paper eject sensor PCB ASSY and fuser unit, and reconnect it. 3 Side thermistor or center thermistor failure Replace the fuser unit. 4 Paper eject sensor PCB failure Replace the paper eject sensor PCB ASSY. 5 Main PCB failure Replace the main PCB ASSY.

Code: E3

Description: Drum position sensor error.
Causes: 1 Harness connection failure of drum position sensor PCB ASSY. 2 Phase displacement of drum gear. 3 Drum position sensor failure. 4 Engine PCB failure
Remedy: 1 Harness connection failure of drum position sensor PCB ASSY Check the harness connection of the drum position sensor PCB ASSY and reconnect it. 2 Phase displacement of drum gear Align the drum phase. (Refer to “6. IF YOU REPLACE THE DRUM DRIVE MOTOR“ in Chapter 4.) 3 Drum position sensor failure Replace the drum position sensor PCB ASSY. 4 Engine PCB failure Replace the engine PCB ASSY.

Code: E4

Description: Run out of paper.
Causes: 1 Main PCB failure
Remedy: Replace the main PCB ASSY.

Code: E6

Description: Write error in EEPROM of the main PCB.
Causes: 1 Main PCB failure
Remedy: Replace the main PCB ASSY.

Code: E7

Description: Main PCB error.
Causes: 1 Main PCB failure
Remedy: Replace the main PCB ASSY.

Code: E8

Description: The scanned data fails to be recorded in the buffer RAM.
Causes: 1 Main PCB failure
Remedy: Replace the main PCB ASSY.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie